Under Pg 2, under the note it states'Note: The DLC9G and legacy DLC9LP cable models draw lessthan 100 mA from the host USB port. In the Datasheet DS300.pdf there is a small blurb that gave me the clue. Hi I've had the exact same problem,I think I fixed this problem for my computer. Hope this experience will save lots of time to someone else. Indeed, after getting my own usb cable, the red light came on right away, but the green one did not come until I provided reference voltage. I thought, what if amazon made up this order themselves and used a crappy usb cable? I actually gave up and started packing the device for return and noticed that USB cable and the DLC9G Programmer came in one box, but different bags. Guys,I greatly appreciate all your input in trying to find out what was the problem with the device.
The first one uninstalls the drivers and the 2nd one re installs them.wdreg -inf uninstall.inf -silent -log uninstall.log uninstallwdreg -inf xusbdrvr.inf -log installxusb.log installHope this helps. I am sure you can find it in this driectory.3) Now give the below commands one after another. Check the screenshot below on where to find the command prompt2) Go to the folder in this command prompt cd C:/Xilinx/14.7/ISEDS/ISE/bin/nt64 on your computer and search for 'wdreg' as shown in the screenshot below. Hi,1) Go to the Xilinx Command prompt (which has the environment variables set already). Here's the screenshot of my device matager:But now I have another problem - when I try to selelect this device in IMPACT, no device is found:At the same time, the console report shows that the driver is present (below), and the device manager says that device is connected (above):Any ideas of what's the problem there?
Someone mentioned to try connecting the device to the USB port that is actually located on the motherboard, so I did it and the device is finally recognized, but no status light is let on the device. When fighting this problem so much, I tried a lot of different things, icluding installing/uninstalling driver via console cmd.exe, I even reinstalled the ISE pack (which installs driver cabels with it) - but with no success.
Any one has an idea of what's the problem with the driver installation? Xilinx Dlc9g Drivers After extracting the files and running the installxusb.bat as administrator, I got the following message from the console window 'cannot run x86 build of this utility on 圆4 platform':The folder of the driver contains both nt and nt64 folders, so I assume that the driver for 圆4 is present. For my Win7 圆4 and ISE 14.7 I downloaded a dirver stated on p.15, Step 5.2. So, I bought the programmer and then followed the guide for device configuration. Coding and simulation went well and now I wish to program a device.
0 kommentar(er)
